GM High Tech Performance
Click here to find out more!
GM High-Tech Performance Blogs

Cold Air Fabrication

Third-Gen F-body
Posted August 27 2012 10:28 AM by Scott Parker 
Filed under: Gm High Tech Performance Magazine, Car Engine

Third-gen fab'd airbox

 Fabricating an airbox on Project Snowball


Airbox & filter
Mock up on car
Mock up, topside
Final assembled and installed



John Ulaszek fabricated this cold air kit for Project Snowball due to a lack of aftermarket support on the third-gen F-body and his desire for an optimized setup that would allow for a large air filter with easy access to remove when needed. This design puts 3-inches of filter inside the engine compartment while isolating it from underhood heat. It is completely handmade with sheetmetal and uses a gasket between the box and the body.



0 comments
  • RSS Feed
    • Add to My Yahoo!
    • Add to Google
    • Subscribe on Bloglines
    • Subscribe on NewsGator
    • MyMSN
    • My AOL
    • Add to NetVibes
    • Add to Rojo
    • Add to NEWSBURST
    • Add to Technorati
    SUBSCRIBE TO OUR BLOGS


GM High-Tech Performance
GM High-Tech Performance